Ivory top alteration and cutting out

Yesterday evening I finally got round to checking the pattern sizing against a tried 'n' tested pattern, doing the forward head and rounded back alterations on all the front, back and facing pieces, laying out on my fabric and cutting out.

I add a wedge across the back which adds an extra inch. And I also take a little bit off the top of the centre back seam. This is a super easy alteration on things which have a centre back seam.

Basically draw a line across the upper back (I do mine about half way up the armhole) at 90 degrees to the grainline. Cut through this from the centre back almost to the armhole leaving a small 'hinge'. Then add extra tissue behind and spread the upper section by the amount you need - 1" in my case. I also curve in the very top of the neckline (not clear on my photo) but same as the image below. That little curve affects the shape of any back neck facing and/or collar pieces, so you'll have to take matching wedges out of them.

Here's someone else's diagram with extra red lines. My alteration is more extreme and further down the back, but you get the idea.

This will then need a matching forward head alteration to remove the excess from the front neckline. 
Again draw the line at 90 degrees to the grainline. Then mark 1" up from the line and draw a second line at an angle back to the hinge point in the armhole. Fold so the two lines meet and tape in place. Alter any facing and collar pieces to match (easiest done by transfering the two lines onto the facing piece and then folding afterwards).

This leaves you with a bit of a step in the edge and you can fill in with tissue if liked. I tend to just mentally add the tissue and cut accordingly.

This leaves the armholes and sleeves exactly the same and thats not been a problem for me.

I thought for ages I needed a small bust alteration but I don't - the excess fabric for me is between the bust and the neck so this is where I need to remove it.
I tend to pick styles with scoop or V neck as I don't like the sensation of a neckline at the collarbone level. However if you do have a higher round neck style and do this alteration, you will need to redraw the front neckline slightly lower, and alter any facing/collar pieces accordingly.

I hope this helps!

Ivory Top Prep cont

feel free to skip over this if you only like to see finished garments!
these are my musings when tackling a new pattern, and some people might find that helpful.
I will also show the alterations I make as I go along as I this might be useful.
------------

Yesterday evening I rough cut the Vogue pattern, and studied the shapes of the pieces as I did so, plus read through the instructions again.
The next step will be to compare to a TNT and think about what alterations I need to make, and how those might affect other pattern pieces (e.g. facing).

Dress/Top
If I want to lengthen the dress it is from the hem.
The front of the dress/top is a really wierd angle so will have to be careful handling, stitching and hemming it. There is already a centre back seam which should make round back alteration easier to do.
I plan on omitting the back zip.
The fabric I want to use is not hugely stretchy but it does meet the stretch guide on the envelope and does return back to shape afterwards. This is a good indicator that it will be OK.
Since there are two pieces for the front, I need to make sure the forward head alteration is done in the same place and for the same amount on both, and that these two alterations will affect the size/shape of the facing pieces which will also need altering.
Note: these are wedge shaped alterations.
The extensions which make the top into the dress will probably need to be cut off for making the top, so I will need to write on them the pattern number, pattern piece etc so they can be reused in future when I make the dress.
I need to check the sleeve width across the bicep area, as my arms are full here. I may need to do a full bicep alteration (not always needed in a knit). I can either measure or compare to a TNT (treied n true pattern).

The little skirt looks really easy, but really short. They provide lengthening lines though, so before I cut the skirt out (a future project) I will measure a previously made skirt which I hemmed to a flattering length, allow for the hem and the elastic waist and lengthen appropriately by adding tissue into the section.
Note: this will just be a simple lengthening, but from above the pleat detail.

The trousers (pants) have a really shallow crotch both front and back. I will compare to my burda TNT and alter accordingly. This is likely to include more wedge alterations. As with the upper body, I add extra at the back, but sometimes need to remove from the front. I am fairly average height so lengths on trousers are normally OK.

The jacket has a peplum, raglan sleeves and a shaped shawl collar. I am limited on fabric yardage (its an Ikea throw) so may cut single collars using the finished edge of the throw, this may change construction around the collar and the shape of the lower part of the collar.
The waist seam needs to sit on the waist, so I need to check the front and back length after I have done the usual round back/forward head alterations. I have a level waist, but sometimes extra length is needed (not often).
Since this has raglan sleeves I may need to adapt the usual round back/forward head alterations for a raglan pattern. Any changes to the bodice pieces affecting the neckline will also impact the collar pieces which will need altering also.
The throw is a loosely woven fabric not a knit, and frays very badly once cut and handled. So I need to cut this one out immediately prior to sewing it up, so best done when I have a chunk of sewing time available.

Vogue 2989 - first item - ivory top prep

I'm going to make this top as my next project.

I read that the pattern is 'close-fitting' so measure myself to find I am a 16/18 top and a 20 hip according to the size chart. So I shall do a test accordingly and see what needs to be altered in addition to the forward head, round back and grading out to the larger hip. I'm also hoping to skip the centre back zip, but will flat finish the back seam (instead of serging it) in case I need to unpick and add it later.

Vogue 2989 Personal Challenge

I have posted Vogue 2989 before but not made it up. Then I thought to myself that i actually fancied trying to reproduce the pieces on the envelope (though of course in my size (16ish) ).

It is for knits only, and for most of the pieces I can do that from stash. The fabric I planned for the jacket is actually a loose woven, so we shall see about that one. And the one piece of black ponte I have is more likely to be the dress than the trousers. I will have to alter everything so lets see if I can do it. In particualr the top and dress are planned for SWAP, as are the Burda trousers I posted a few days ago. So those will get done first before I move on to the jacket, skirt and trousers from this pattern. Somehow I don't expect to look quite like the Vogue model when everything is done!

Ivory marl cardigan jacket

The ivory marl cardigan jacket is complete. This is the eighth item in the verdigris SWAP and has an optional cowl scarf I cut out at the same time as the jacket.

The fabric I used was a a loose weave textured fabric which ravelled terribly, and needed both the sewing machine and immediately afterwards the overlocker to finish each seam. However it has pressed nicely and works well in this soft cardigan style jacket.

The pattern in the short jacket from New Look 6082.

Spring Black Trousers Sew Along - Pattern

I have decided I am going to use a Burda pattern I have used before for my black trousers.

It is from Burda February 2010 and is a wide legged trouser with slant front pockets and an invisible zip.

I have an ivory cardigan I want to sew first though, so will be another week when I can get to this.

Ivory Stripe Shell blouse

This Ivory woven top is another round necked top from the dartless tee blouse block. It has long sleeves, a bias bound neckline and a la centre back seam to accommodate my forward head, rounded back and sway back.

The stripes are woven bands in the fabric, and the wider sections in between are slightly crinkled. The bands have no give whatsoever so I went for a skimming fit, which looks quite nice on the body but appears rather short and wide when laid out on the carpet and photographed.
There will eventually be pictures of me wearing it, sometime in May!

As ever with simple pieces like this, I hope it will become a staple in the wardrobe as the simple style should work with lots of other things.

This is the seventh item in the verdigris SWAP 2014.

Spring Black Trousers (Pants) Sew Along (March/April 2014)

Hiya everyone, both YorkshireLass and I have plain black trousers in our SWAP plans, but were not finding the impetus to somehow get it done. Plain black is kinda boring.
So we thought we'd have a sew along between ourselves.

If you want to join us you would be welcome.

The timescales are something like this.

March 1st to 14th -  think about joining, find fabric and pattern, make muslins etc
March 15th/16th - start some point over this weekend
carry on working away at your trousers and aim to finish by end of April.



The trousers (pants) can be any style, size and for anyone (though we are making for ourselves) and need to be made of any plain black fabric.

Post pictures of your finished trousers on Stitchers Guild for all to see, any time in March or April.